Your garment has been designed to use one of Inuheat’s various types of magnetic connectors to attach the PowerPack to your heated garment.
CONNECTOR CLIP
If your garment has the “Clip” style connector like shown here, push the PowerPack onto the connector until you hear a “click” that confirms the PowerPack is properly attached. It should not move relative to the connector if properly attached.
To remove the PowerPack from the Connector Clip, press down on one of the ears on the side of the Clip and detach the PowerPack from the garment.
CONNECTOR PLATE
If your garment has the thin Plate Connector style like shown below, simply locate the recessed area under the PowerPack and mate it onto the raised connector Plate Bar. You should hear a “click” once the PowerPack is properly seated.
Garments with Connector Plates typically also have a secondary solution to help hold the PowerPack in place during use, such as a fold-over flap, a pocket, a Velcro holder or other design. Use these design aids as well to properly secure your PowerPack prior to use.